![]() ![]() If your ReadyNAS is still on after 20 minutes, then it is likely that the recovery process failed. The ReadyNAS USB Boot Recovery mode is very picky about the USB you use.When the ReadyNAS completes the recovery, it will power down the device then you may remove the USB and try booting normally.On rackmount units with VGA, you can connect a display to watch the update process.2-bay desktop units, you may not be aware when the unit enters USB Recovery mode, unless your USB has an activity indicator.Units enabled with LCD will indicate that it has entered USB Recovery mode.Start the chassis and continue holding the Backup (or Reset on Rackmount) button for up to 15 seconds. Before powering on the device, press and hold the Backup (or Reset on Rackmount) button.On a rackmount unit, place the USB in any available port. If you have a desktop model ReadyNAS, place the prepared USB in the front USB port while the unit is in a powered down state.Select the firmware under "Select Firmware image:".Select the drive letter the USB was assigned under "Select the USB Drive:".Open usbrecovery.exe from the Recovery Tool folder on your desktop.Identify the drive letter your USB is assigned after formatting.Ensure there is only one partition on the USB.Find a USB that is greater than 256 MB but no more than 32 GB.Extract the firmware file and release notes from the zip file to the same folder you extracted the Recovery tool.Download the final RAIDiator 4.2 firmware (4.2.31) from.Extract RAIDiator 4.2 USB Flash Recovery.zip to a new folder on your desktop.Download the RAIDiator 4.2 USB Recovery Tool.Using the USB Boot Recovery could cause irreparable damage to the chassis if used incorrectly: powering down the chassis prematurely during write operations, or attempting to downgrade the firmware of the chassis. The USB Boot Recovery program attempts to overwrite existing firmware data inside of the chassis. Read through all of the steps and make sure you feel comfortable in proceeding otherwise, do not proceed with the steps below. This tool should only be used at the recommendation of NETGEAR Support. A tool to revert your chassis to an older firmware in an attempt to downgrade your existing setup's firmware.A magic fix-it-all-in-one utility to resolve non-chassis issues.A recovery tool for reloading current firmware onto the chassis for recovery purposes only.A solution is to try using the USB Recovery tool to reflash firmware on the ReadyNAS chassis. The unit may not be fully bootable at this point. When the chassis reboots into normal mode, it might proceed with trying to upgrade your chassis with the poorly copied firmware image, fail, and still try to start up. Generally, this happens because the new ReadyNAS firmware was not fully written to the chassis due to something unexpected during upgrade. Not what you're looking for? Return to the ReadyNAS Not Accessible FAQ. In the event of a firmware upgrade failure, your ReadyNAS may be unable to boot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |